C-54(.01mfd).
There is a capacior symbol printed on the lower left (outside) of VFO shield line but no number is printed,
that I have found is C-54(.01mfd).
C-83 in the mic section is marked as electrolytic capacitor, but that infact is .1mfd disc.
C-149 printed on lower right corner of the board, near R-118 PS I think is C-146(.1mfd)??
C-99 printed near IC-4 infect is C-89(100pf disc)
C-90-- In cw delay section,just next to VFO box,on right side, just below D-23/22 printed is C-90, but this is C-98 (47mfd).
The actual C-90(.1mfd) is towards pin 8/9 of ic4.
R-88 is printed at 3places on board. R-88 printed on the left side of the board toward J12,
is R-83, value is 2k2. 2nd R-88 left of T6 is ok, 3rd R-88 towards right side of baord, near r74 PS,
is R-80 and value is 1k.
D-28 and D-29--Right side of the board, just next to PS-R82,are printed D-28 and D-29, but they
actually are D-19(3V3 zener) and D-20(1N4148).
-D-26 and D-26A: D-26 below Q-17 is ok and just on the left of this diode printed A is D-26A, 2 zeners (15V/.4W) back to back.
C-154: The number is printed but not symbol. It will go between Q17 and R-160.
D-29- There is one 60-70V/1W zener grounded from Drain of Q17, the number should have been D-28, there is another D-29(OA79), which is near S-meter, and there is another D-29-32, that is part of power supply, makes birdge rectifier.
R-5 printed at two places. R-5 (100E)near T2 right lower corner is ok, but 2nd printed near "IN" of xtal filter is R-6(1k)
C17: (.01mfd disc) is capacitor just below T-3, number is printed but not symbol. one side of this capacitor goes in the middle hole just below T3 and other side goes on left side hole.
C-90,C-98: C-90 is printed near R110 PS. This is near upper right corner of VFO shield line. This is C-98(47mfd Electro) and not C-90 as printed.
L2,VFO coil: I have made coil on 1.4cm former with 26swg wire, 42 turns, I have found that you need about 6' 8" of
wire to make this coil. |
Forum
